Beading - Non flat edge


Postby ldoodle » Mon Mar 08, 2010 9:41 am

Hiya,

I need to nail some beading to the corners of an opening (used to be the external door until the extenstion was added) but the edges are not straight.

Basically there are a few small arcs down the edge which means the beading would be floating in those sections.

The top and bottom bits are OK so I can get a straight line from top to bottom but the bits in the middle are causing problems.

Is the only way round this to build up those sections with filler of some sort?

Thanks
ldoodle
Posts: 8
Joined: Wed Mar 28, 2007 12:27 pm

Sponsor

Simply Build It

Postby stoneyboy » Wed Mar 10, 2010 8:43 pm

ldoodle,
"Is the only way round this to build up those sections with filler of some sort" YES fit the beading then fill the gaps.
end
stoneyboy
Posts: 2708
Joined: Wed Dec 10, 2008 6:44 pm


Display posts from previous
Sort by
Order by


 


  • Related Topics