Pressur loss on ideal logic + bolier

[howie2627]

i have an ideal logic + boiler, the pressure has started to drop but the radiators are full and have been bled, any help would be greatful.

[Iron Fist]

THIS IS OFTEN CAUSED BY A LEAK SOMEWHERE IN YOUR SYSTEM TRY ADDING A LEAK SEALER INTO ONE OF YOUR RADIATORS . TURN OFF THE VALVES ON BOTH SIDES OF YOUR RADIATOR WHEN THE SYSTEM IS COLD REMOVE THE BLEED NUT ( BEST ONE TO USE IS OFTEN A TOWEL RAIL BECAUSE THESE ARE OFTEN ON THE TOP OF THE RADIATOR PIPE MAKING IT EASIER TO ADD THE LEAK SEALER ) ADD THE LEAK SEALER REPLACE THE BLEED NUT TURN THE VALVES BACK ON TURN YOUR HEATING ON ABOUT 25 DEGREES AND RUN FOR BETWEEN 4 AND 6 HOURS . CHECK THE PRESSURE AND SET TO THE BOILER RECOMENDATION . THIS MAY NEED TO BE DONE A COUPLE OF TIMES , ALL THE BEST [/code][/b]

[Perry525]

When you let air and water out of your radiators, you automatically lower the system pressure. There should be a tap under the boiler where you can let in more mains pressure water to bring the system up to 1 bar.