TABLE SAW BLADE


Postby greengrass » Sun Apr 25, 2010 5:48 pm

As there doesn't appear to be a tools section, unless I've had a 'word blind' senior moment.

I have a Ryobi table saw and cleaning the saw dust out of the innards notice on checking the blade alignment it runs very slightly off as though buckled should I stop using it ?.

Most of my cuts are carried out with the blad protruding 1 inch above the timber to be cut so lttle blade is showing.
I've check the drive shaft is doesn't appear to be that.
greengrass
Posts: 177
Joined: Wed Mar 14, 2007 7:27 pm

Sponsor

Simply Build It



cron