by darrenshields »
Tue Feb 12, 2008 2:36 pm
I have an oil heating burner with a dual stat, 1 for high temp cutout set at 90 deg, the other adjustable, set at 75deg to control the temp of the rads. The system runs fine off the timer but when it goes off at the required time, it wont come back on the next time its supposed to, normally the next day. I have to reset the high temp cut-out stat to get it going again. its been like this from day 1 and so far I've replaced the dual stat but it still happens. Any suggestions gratefully accepted!
