UPDATING TO DOWNLIGHTING

by **jjsingleton101.wanadoo.co** » Mon Apr 14, 2008 8:03 pm

I AM REPLACING MY CENTRAL KITCHEN LIGHT WITH DOWNLIGHTS (SPOTLIGHTS).I NOTICED IN A PREVIOUS FORUM QUESTION THAT IT WAS STATED YOU CAN USE FLEX TO WIRE THE SPOTS INSTEAD OF CABLE,IS THIS THE CASE ON A 240V INSTALLATION?
I AM GOING TO INSTALL A JUNCTION BOX IN THE CIELING BY THE EXSISTING ROSE,CAN I RUN EACH SPOT FROM THE LAMP CONNECTION IN A CURCIUT.
THANKS PHIL

by **BLAKEY1963** » Mon Apr 14, 2008 10:07 pm

[quote="jjsingleton101.wanadoo.co"]I AM REPLACING MY CENTRAL KITCHEN LIGHT WITH DOWNLIGHTS (SPOTLIGHTS).I NOTICED IN A PREVIOUS FORUM QUESTION THAT IT WAS STATED YOU CAN USE FLEX TO WIRE THE SPOTS INSTEAD OF CABLE,IS THIS THE CASE ON A 240V INSTALLATION?
I AM GOING TO INSTALL A JUNCTION BOX IN THE CIELING BY THE EXSISTING ROSE,CAN I RUN EACH SPOT FROM THE LAMP CONNECTION IN A CURCIUT.
THANKS PHIL[/quote]

PHIL
I would consider heat resistant flex.
because u would b altering earth loop impeadances by enlarging
lighting circuit , i would seek advice of part p sparky.
just to guide u . most give free quotes.

BLAKEY1963

by **jjsingleton101.wanadoo.co** » Sun Apr 20, 2008 3:31 pm

thanks blakey.